(1)液位控制儀表系統指示值變化到或小時，可以先檢查檢測儀表看是否正常，如指示正常，將液位控制改為手動遙控液位，看液位變化情況。如液位可以穩定在一定的范圍，則故障在液位控制系統；如穩不住液位，一般為工藝系統造成的故障，要從工藝方面查找原因。

(2)差壓式液位控制儀表指示和現場直讀式指示儀表指示對不上時，首先檢查現場直讀式指示儀表是否正常，如指示正常，檢查差壓式液位儀表的負壓導壓管封液是否有滲漏；若有滲漏，重新灌封液，調零點；無滲漏，可能是儀表的負遷移量不對了，重新調整遷移量使儀表指示正常。

(3)液位控制儀表系統指示值變化波動頻繁時，首先要分析液面控制對象的容量大小，來分析故障的原因，容量大一般是儀表故障造成。容量小的首先要分析工藝操作情況是否有變化，如有變化很可能是工藝造成的波動頻繁。如沒有變化可能是儀表故障造成。